HeroMe Gen 7 mount for BTT Eddy Duo eddy current sensor

A mount for the BTT (BigTreeTech / Biqu) EDDY DUO ABL eddy current sensor on the HeroMe Gen7 printhead assembly.

Derived from the existing ABL mount "HMG7.2 Hallon Medium ABL Left Mount", which is too short for the "BTT EDDY DUO" sensor in combination with a Volcano hotend.

The slit for the nut holding the sensor is refined to give a better fit.

v3 is a strengthened, bulkier version.

Print orientation has been optimized to minimize support.

BTT EDDY Duo https://biqu.equipment/products/bigtreetech-eddy

Print Settings

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.14 - 0.28

Infill:

45

Filament Material:

ABS

Notes:

I printed this in ABS (Geeetech ABS+) like all my HeroMe parts.

For all HeroMe parts, I use

• outer layer height: 0.14mm

• inner layer height (inner perimeters and infill). 0.28mm

• line width 0.6mm

• 45% infill (not really needed here though)

• adaptive cubic infill

• automatic tree support with lean trees, on buildplate only, "only critical" NOT checked

and two postprocessing scripts in OrcaSlicer 2.3.0

• https://github.com/TengerTechnologies/Smoothificator

• https://github.com/TengerTechnologies/Bricklayers
  in this version
  https://github.com/TengerTechnologies/Bricklayers/blob/main/NonPlanarInterlockingWalls.py
  settings see file "settings.zip"

  The .3MF is for OrcaSlicer 2.3.0, the _generic.3mf is exported from OrcaSlicer als "Generic 3MF",
  whatever that means.

  STL is exported from OrcaSlicer. Go for the 3MF if possible.

How I Designed This

Just a few modifications in OrcaSlicer ("add part" / "add negative part").

Category: 3D Printer Parts