1 / 2
Raspberry Pi Rack Rack - MODS
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The original design was fantastic, but I found I needed to make a few changes to work with what I had.
The Faceplate was modified to accept an SSD1306 128x32 OLED. I've found there are a bit easier and cheaper to acquire. It's a good fit that should stay in place, though a dab of hot glue wouldn't hurt. I also extended the mounting holes for the fan screws just a bit to better accommodate the hardware I had without trying to push through the front.
The Pi 3-4 Tray was modified to allow using M2.6 screws to mount the Pi to the base. I found the stubs in the original to be fragile and prone to popping off.