Airbrush turntable, 18cm, two 608 bearings for stability
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
18cm diameter turntable using two 608 bearings for added stability compared to just one.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 40
- Wydruki
- 2
- Wyświetlenia
- 236
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I needed an airbrush turntable for a project. Even though relatively lightweight, I wanted more stability for the platform so used two 608 bearings instead of just one. I also did not want to worry about getting an exact fit and fine tuning the XY compensation, so designed the bearing holding features to have some give and the bearings press-fit in place. For the first turntable bearing, I used a small closed-end wrench a bit smaller than the bearing diameter to press it down to make sure I pushed it with an even force to get it past the initial bearing feature and to set it in place. Add the first bearing, place turntable into the base, add the second bearing on the bottom.
Printed in PETG, but PLA or other filaments should also work well.
.2mm height, three perimeters overall, with an added modifier of 7 layers for the axle area of the top piece to make it stronger, details in the .3mf file. It also has a hole all the way through the middle for a complete wall top to bottom to avoid a weak thin layer on top of infill right at the turntable level, although with the added 7 layer modifier this isn't really necessary. You might get a warning about long bridging extrusions for the base, this is at the bottom bearing. I added some bridges into the model, supports should not be needed. I printed in PETG and only a small amount of clean up around the hole was required, much less than removing supports.
OrcaSlicer now includes this as an optional feature, hopefully PrusaSlicer follows suit soon. https://github.com/SoftFever/OrcaSlicer/wiki/quality_settings_bridging#bridge-counterbore-hole
Bearings I used: https://www.amazon.com/dp/B09QKP38SW