1 / 4
TL SMOOTHER HOLDER 2020 EXTRUSION AND ANYCUBIC PREDATOR — zdjęcie 1
1 / 4

TL SMOOTHER HOLDER 2020 EXTRUSION AND ANYCUBIC PREDATOR

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix from SolidRye. I have included pictures of the TL smoothers I have. They did not fit in SolidRye's…

Ocena
0 / 5
Polubienia
5
Pobrania
27
Wydruki
0
Wyświetlenia
301
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a remix from SolidRye. I have included pictures of the TL smoothers I have. They did not fit in SolidRye's holder due to the pins protruding on the bottom side of the circuit board. I modified the holder to have openings so they would sit flat. Also, the quality control on the circuit boards was a bit off and I had to size the holes about 1mm smaller.

Printing SolidRyes part was not easy and would have required supports. I changed the design to be mounted to the extrusion with 2 bolts and 2 extrusion nuts. It now sits flat on the bed and can be printed without supports.

I put 2 dabs of hot melt glue in opposite corners to help hold each board. Pics show everything.

Note to self and others, in the future, I would buy TL Smoothers with heatsinks. The diodes get really warm and really need the heatsinks. I got a deal on mine for $5 for 3, but next time I would spend more and get heatsinks on them. The diodes are too small and too close together to use stepper motor heatsinks. I will now have to look for different size heatsinks I can use.

Source file in Sketchup is included in case you want to modify.

Category: 3D Printer Parts

Tagi