Gridfinity Bin for Arduino Uno
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity bin to mount an Arduino Uno.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 158
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE (Sep 21, 2026):
I've created a version with an increased height which would allow other bins to stack on top without bumping into the Arduino board. The original version has a height of 2U in Gridfinity terms, so I’ve added a 3U version.
Overview:
This is a remix of Patrick Ruiz’s gridfinity bin for an Arduino Uno. His version has pins that locate the Arduino, but they do not secure it. It is a 2x2 Gridfinity grid based on Zach Freedman’s platform: https://gridfinity.xyz/. I removed the magnet holes from the bottom and created two alternate versions:
1. Mounting holes for screws – These holes can be tapped with an M3 tap. Secure the Arduino Uno using M3x6 or M3x8 screws.
2. Mounting holes designed for heat set inserts (M3x4x5) which are even more reliable using the same screws.
I also flared the mounts to add some strength to them. I use this bin with a custom tray I made that utilizes Clickfinity plates by NoWarranty (https://www.printables.com/model/452675-gridfinity-clickfinity-baseplate-no-magnets-univer).
Printing:
Print in any filament you wish. No supports required.