1 / 2
Replacement wheel and pin for Kenmore Elite dishwasher — zdjęcie 1
1 / 2

Replacement wheel and pin for Kenmore Elite dishwasher

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement wheel and pin for Kenmore Elite dishwasher, bottom rack.

Ocena
5 / 5
Polubienia
4
Pobrania
23
Wydruki
1
Wyświetlenia
76
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution

Apologies for the gross picture - our dish detergent leaves a terrible residue buildup over time, but i digress…

One wheel of the lower rack on my dishwasher had completely broken off and another was in bad shape (I have kids). I tried to just get a replacement set, but the wheels on it were smaller and so the rack sat too low and impacted the lower washer arm. So, to Fusion I went.

These wheels fit a little better than the original (smaller tolerance) without the wobble but still free spinning. The pin/plug is also tighter, at least compared to my well worn dishwasher. The stock wheels were very easy to take off the brackets. This pin feels pretty permanent - once pressed in and “clicked” (rim bulge), it really doesn't want to come out. If you need to get it out, I suggest just breaking it from the back side and printing a replacement - not worth the trouble otherwise.

These wheels are ever-so-slightly larger diameter than the stock wheels, by intent. And I mean by like a millimeter or two. The replacements I had found were too short, and the stock ones sagged and caused problems, so to ensure long life without sagging and letting the rack impact the lower washer arm, I made these a little taller and printed with stout infill (like 50%) in hopes they would hold and not deform. So far so good, even with PETG (I plan to reprint if the material breaks down - I have some ASA and ABS on hand but was testing with PETG and the PETG so far seems to be holding up well).

No one may ever need this, but I took the hour to model and test print, so here it is. 

Tagi