Replacement wheel and pin for Kenmore Elite dishwasher
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement wheel and pin for Kenmore Elite dishwasher, bottom rack.
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 23
- Makes
- 1
- Views
- 77
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
Apologies for the gross picture - our dish detergent leaves a terrible residue buildup over time, but i digress…
One wheel of the lower rack on my dishwasher had completely broken off and another was in bad shape (I have kids). I tried to just get a replacement set, but the wheels on it were smaller and so the rack sat too low and impacted the lower washer arm. So, to Fusion I went.
These wheels fit a little better than the original (smaller tolerance) without the wobble but still free spinning. The pin/plug is also tighter, at least compared to my well worn dishwasher. The stock wheels were very easy to take off the brackets. This pin feels pretty permanent - once pressed in and “clicked” (rim bulge), it really doesn't want to come out. If you need to get it out, I suggest just breaking it from the back side and printing a replacement - not worth the trouble otherwise.
These wheels are ever-so-slightly larger diameter than the stock wheels, by intent. And I mean by like a millimeter or two. The replacements I had found were too short, and the stock ones sagged and caused problems, so to ensure long life without sagging and letting the rack impact the lower washer arm, I made these a little taller and printed with stout infill (like 50%) in hopes they would hold and not deform. So far so good, even with PETG (I plan to reprint if the material breaks down - I have some ASA and ABS on hand but was testing with PETG and the PETG so far seems to be holding up well).
No one may ever need this, but I took the hour to model and test print, so here it is.