Bigtreetech SKR2 + Rasperry Pi Zero 2 + Noctua Fan Enclosure for Ender 3 v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an Electronics front enclosure for Ender 3 V2, it is designed to fit: Bigtreetech SKR 2 Raspberry Pi Zero 2 1x…
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 19
- Wydruki
- 1
- Wyświetlenia
- 1004
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is an Electronics front enclosure for Ender 3 V2, it is designed to fit:
Bigtreetech SKR 2
Raspberry Pi Zero 2
1x Noctua Fan 92x10
Needs the feet extensions already installed.
For specific to the parts I had available and the limited length cables I had. It's very difficult to work on once it's in.
I'm making improvements over time but it's big & expensive to keep printing for small changes.
Related Klipper config via my GitHub repo: https://github.com/simeonpashley/klipper_config
Print Settings
Notes:
I printed it in Hatchbox PETG for improved heat resistance but it's very flexible, which is noticeable when mounting and the whole thing flexes.
While eSUN PLA+ is much stiffer, I wasn't sure on how hot it was all going to get so plumed for PETG.
How I Designed This
I made a lot of variants to get to this point as the whole thing is very densely packed and there's no room for changes. I tried inverted (same as the stock mount) and various positions & orientations.
Specifically aimed to keep the cables as close to the back-left as possible as I run a Hemera direct drive and the provided cables barely reach this position.
rPI zero 2 mount is separate and fixed with 2.5mm screws through the front grid.
From front - grid of holes are partly air flow, partly where the rPI is mounted
right said - just a 92mm noctua. Optional shelf ledge
Left side, tightly packed. SKR, rPI Zero 2 and buck converter for fan
From right looking under Y rail
From left looking under Y rail
Category: 3D Printers