Sunlu S1 Plus dryer desiccant (loose beads of silica gel) holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
desiccant holder for Sunlu dryer
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 354
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Desiccant holder to fit inside Sunlu S1 Plus dryer with back ptfe outlet
Holder is designed to hold loose beads of silica gel
Hole 12mm diameter to be drilled 33mm above bottom edge of top dryer cover
Please be gentle while fitting top lid ( list holder to left and right moving beads out of slots while clicking it in), do not full fill holder with beads, leave around 4-5 mm top empty.
printed with ABS (recommended)
From the photos you can see that hole for plug is slightly off centre, it is because i had hole drilled in ther long time ago which was not exactly in the middle , but model in file is with hole in the middle.
i used optional rubber o-ring under plug (as per photo)
0.4 nozzle
0.2 layer height
no supports
Here is link to bowden splitter which helps dryer to go in tandem with Qidi Box (AMS)
https://www.printables.com/model/1413138-bowden-y-splitter-for-qidi-box-ams-pc4-m6
and hygrometer bracket for dryer :
https://www.printables.com/model/1432376-sunlu-s1-plus-dryer-hygrometer-bracket
Thank you