1 / 2
Holder for Rechargeable Lithium D Cell Batteries, Charging Block, and Quad USB Charge Cable
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Storage holder for 5 cell and 8 cell batteries with a place for the cable and block using minimal filament.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
I made this to keep everything together in one place. The cable holder is 9 X 16mm, the block holder is 24 X 38mm, and the battery diameter is 33.5mm but all sizes are a little less due to plastic shrinkage. It stands 30mm high. Very little infill, with 3 walls it is nearly all solid plastic. I adapted the 8 cell to a 5 cell for anyone needing a smaller holder. I have not printed it, but it is the same minus 3 cells. I printed the model in PLA with no special settings.