Meshtastic Seeed Studio XIAO ESP32S3 & Wio SX1262 case MOD with screen and INA219 voltage reader
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a revision to add a .96 inch screen, button, INA219 voltage reader, and include a 1000 mAh battery.
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 1399
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model has some space removed internally on both the case and back cap in order to fit desired components such as a tactile button, .96 OLED Screen, and a INA219 voltage meter. The meter allows the user to view voltage state on-board as the S3 cannot read battery percentage to my knowledge. Magnet wire is desired to reduce component space usage. I have attached a hexagon patterned front, as well as a blank front and blank back cap.
NOTE: the OLED Screen is hot-glued into place, as is the tactile button, the S3 chip as shown, and the power switch on the top screw hole. All hold firm. I suggest soldering the the wiring to the S3 before gluing or mounting to the case.
The screen can be found here: https://a.co/d/12qW2rQ
The battery can be found here, and is a 803040 1000 MAh battery. https://www.amazon.com/dp/B0CNLPBM2L?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1https://www.amazon.com/dp/B0CNLPBM2L?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
The INA219 can be found here: https://www.amazon.com/MTDELE-Bi-Directional-Current-Breakout-Compatible/dp/B0FG2CHL6R/ref=sr_1_4https://www.amazon.com/MTDELE-Bi-Directional-Current-Breakout-Compatible/dp/B0FG2CHL6R/ref=sr_1_4
To wire-
BATTERY and ON-OFF SWITCH: Connect the battery (+) to the HIGH SIDE solder pin hole on the INA219 Vin (+), then run a wire from the high side Vin (-) to the on-off switch, and then to the battery (+) pad on the underside of the S3 chip. The battery (-) gets wired directly to the battery (-) pad on the underside of the S3 chip.
THE BUTTON: One pin is wired to GND on the OLED Screen, or GND on the S3. I chose the screen for ease. The other pin of the tactile button is connected to GPIO4 on the S3 chip.
THE REST: These 8 magnet wires are all pre-cut to 4mm each, and could be shorter. Connect all corresponding leads (the first four starting with GND, VCC, SDA, and SCL) from the INA219 to the .96 OLED, and then connect those leads from the OLED to the S3 corresponding solder pin holes as GND, 3V3, SDA and SCL. I suggest using tape on the backside of the OLED in order to protect circuitry as shown.