Liczymy pasujące modele…
Printed template for DIY small 868MHz / 915MHz antenna. Total size 26x6mm alternative to 160mm dipole. Use 0.7mm wire to make the antenna spring. Use coaxial IPEX4 antenna cable, solder active, central wire to the spring (no passive part…
This is a Helical Antenna for the 915mhz band. Intended to be used with rocket avionics but will work for any 915mhz application. Copper wire is 1.7mm solid coper. Build Video can be seen here https://youtu.be/JCoJQt3CkDY Print Settings…
This is my attempt at a very small case for the Femtofox Meshtastic node. More information on the Femtofox can be found here: https://github.com/femtofox/femtofox Some notes: Additional Components: N Female to IPX/UFL RG178 Cable - 10 cm…
868Mhz / 915MHz Antenna Dipole cover and mounts To get different angle mount and have antenna 10-15mm below bottom plate use lighter to gently warm-up printed handler . It will be much stronger then print of angled mount due to filament…
The 915MHz cavity filters from ACASOM are a bit spikey because of the exposed screwheads poking out the top. I wanted to use one with a FemtoFox but was worried about the exposed bits damaging something else in the enclosure and made…
Wall mount with extension from the wall. Insert Nuts M3xD4.6xL5.5.
Retainer for holding down the U.FL/IPEX connectors on the wehoop4 915MHz BPF. Needs M2.5 machine screws. I would recommend M2.5x6, but M2.5x8 (what I used in picture) works fine too.
I purchased a inexpensive cavity bandpass filter off AliExpress for my MeshCore repeater. The idea location to place it is as close to the antenna as possible but that required mounting it outside and on my tower. I needed a waterproof…
a case for the antenna designed by daveintheshop on youttube. makes a handmade copper antenna a lot stronger and easier to mount to a surface. the halves are glued together with your favourite glue. the mount can have a hole drilled for a…
Retainer for holding down the U.FL/IPEX connectors on the wehoop4 915MHz BPF. Needs M2.5 machine screws. I would recommend M2.5x6, but M2.5x8 (what I used in picture) works fine too.
Wall mount with extension from the wall. Insert Nuts M3xD4.6xL5.5.
