Alternate Vent Lever for Core One Automatic Chamber Vent
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modification of the Vent Lever from the original design, adds a flange to support the lever from both sides.
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 41
- Wydruki
- 4
- Wyświetlenia
- 563
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted to use the model to close the vent as part of the End G-Code script, but I could not get the closing to work correctly due to the lever pivoting a little around the screw and exerting a torque which would increase the force required to move it significantly. Tightening the screw further would instead increase the friction between vent and grate too much.
To solve this I extended the design to have support flanges on both sides and it sits nice and tight.
Print instructions:
0.2 Layer height
15% infill
Supports for the top flanges
See image for orientation on the build plate
NOTE!
If you change to this part you need to update the End G-Code script provided in the original design slightly to adjust for the added width. I would still recommend manually checking the positions yourself, but the script below is the one I use.
; ------------------------------------------
; Close the vent if it has been opened{if filament_type[initial_tool] =~ /.(PLA|PETG)./}
G1 Y0 F10000 ; go to safe position
G1 X120 ; right of lever
G1 Y-7 ; engagement position
G1 X105 F1000 ; push lever left
G1 X120 F10000 ; retract to the right
G1 Y0 ; go to safe position
{endif}
; ------------------------------------------