Jeanneau tank cap for water level gauge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Freshwater tank cap used in many Jeanneau boats modified to install a water level gauge
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 128
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement for the original freshwater tank cap found in many Jeanneau boats, modified to install a water level gauge that surprisingly was absent in several models of the brand.
Just like the original cap you must use it with a 120 x 8 mm O-ring.
The original is a plastic injection part that threads on the the polyethylene tank opening and presses the 120 x 8 mm O-ring. Initially I tried to make an exact copy of the original cap but after many tests I found that when the tank was brim full it leaked, so I changed a little bit the design to improve the sealing of the O-ring and now is totally watertight.
However 3D printed parts, even when printed at 100% infill and many perimeters, are normally not waterproof when subject to pressure, so I suggest post processing by impregnating it with epoxy resin.
Please note that this is not the original part from the shipyard, so you must use it at your own risk. I recommend performing leak tests, especially when the tanks are filled to capacity.
The water level gauge I used is the standard one that comes in several rod lengths, depending on the depth of the tank, and that is commonly used in boats, campers, etc. You need to measure your tank before ordering the correct model.
As a by-product I have a non-perforated version of the tank cap, that is a good replacement for the original part:
https://www.printables.com/model/1435004-jeanneau-freshwater-tank-cap