1 / 4
Sovol Filament Dryer SH01 - Filament Guide Taller with M3x10 Screw Remix — zdjęcie 1
1 / 4

Sovol Filament Dryer SH01 - Filament Guide Taller with M3x10 Screw Remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The original model has been adjusted to allow filament to feed from both left and right sides of the dryer

Ocena
0 / 5
Polubienia
3
Pobrania
12
Wydruki
0
Wyświetlenia
187
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

I had difficulty with the original model (the M6 bolt broke while installing), so I ended up creating adapters to make it work. After using it for some time, I decided to make a proper remix and make a few other adjustments to print from both sides of the dryer. I used a bit of cork adhesive to friction mount to the lid. I recommend PETG to avoid warping from the heat of the dryer. If you use PLA, remove the guide while drying.

Print 4 copies of the Pulley Half

11/2/25 Update

I've reprinted the body in PETG now that the PLA version has warped.

Print Settings

Resolution: 
0.2mm

Infill: 
15%

Notes: 
3 Walls

Post-Printing

  1. Insert 608 2RS bearing into both Pulley Half prints

  2. Install Pulley onto filament guide

  3. Secure Pulley by screwing on Bearing Retainer with 3x10mm screw

  4. I recommend applying cork adhesive to the inside of the feet for a tight fit on the lid

Tagi