1 / 4
Sovol Filament Dryer SH01 - Filament Guide Taller with M3x10 Screw Remix — image 1
1 / 4

Sovol Filament Dryer SH01 - Filament Guide Taller with M3x10 Screw Remix

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The original model has been adjusted to allow filament to feed from both left and right sides of the dryer

Rating
0 / 5
Likes
3
Downloads
12
Makes
0
Views
187
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Share Alike

I had difficulty with the original model (the M6 bolt broke while installing), so I ended up creating adapters to make it work. After using it for some time, I decided to make a proper remix and make a few other adjustments to print from both sides of the dryer. I used a bit of cork adhesive to friction mount to the lid. I recommend PETG to avoid warping from the heat of the dryer. If you use PLA, remove the guide while drying.

Print 4 copies of the Pulley Half

11/2/25 Update

I've reprinted the body in PETG now that the PLA version has warped.

Print Settings

Resolution: 
0.2mm

Infill: 
15%

Notes: 
3 Walls

Post-Printing

  1. Insert 608 2RS bearing into both Pulley Half prints

  2. Install Pulley onto filament guide

  3. Secure Pulley by screwing on Bearing Retainer with 3x10mm screw

  4. I recommend applying cork adhesive to the inside of the feet for a tight fit on the lid

Tags