Audi/VW SAI Filter Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use most current revision STL file, rev B. When installing a "cold air" intake on Audi/VW vehicles equipped with…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 123
- Wydruki
- 0
- Wyświetlenia
- 858
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Use most current revision STL file, rev B.
When installing a "cold air" intake on Audi/VW vehicles equipped with secondary air injection (SAI), the inlet hose to the pump needs a filter since it normally connects to the factory airbox assembly. Aftermarket "cold air" intakes replace the air box assemebly. This adapter allows one to use a 1 inch ID breather filter on the SAI hose while utilizing the factory connector.
Print Settings
Printer:
Tevo Tarantula
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.25mm
Infill:
100%
Notes:
I would use 100% infill to ensure a high strength part. But, be gentle when tightening the hose clamp on the breather to prevent crushing the pipe.
I designed this part to alleviate issues with overhangs. However, when printing with the large base on the bed (as intended), the notch required for clearance on the factory hose connector causes a bridge, therefore supports should be used; but they're not necessary.Category: Automotive