🔑 Ninebot MAX G30D eScooter Chain Holder/Kettenhalter/Schlosshalter (3cm chain-Ø)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a "clamp-on" design chain holder for the Ninebot G30D escooter and a max chain width of 3 cm.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 75
- Wydruki
- 1
- Wyświetlenia
- 1232
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Please leave a ♥ Like if this print was helpful to you :-)
This is a "clamp-on" design chain holder for the Ninebot G30D escooter and a max chain width of 3 cm. Holds the lock securely in place when not needed and also makes locking it on somewhere much easier.
SEE THIS PRINT FOR OTHER SCOOTERS.
You need:
- ASA to print for outdoor durability
- 4 x M4x20 screws
- 4 x M4 nuts
- Loctite (optional)
A good assortment to get started is something like this.
Print Settings
- Rafts: No
- Supports: Yes
- Resolution: 0.2mm
- Infill: 30
- Filament: Prusament ASA Black
Depending on your printer, supports below the ring that holds the chain might make sense. Choose the infill to your liking, I would recommend at least 20 % - but going beyond 50 % probably doesn't make any sense either.