🔑 Ninebot MAX G30D eScooter Chain Holder/Kettenhalter/Schlosshalter (3cm chain-Ø)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a "clamp-on" design chain holder for the Ninebot G30D escooter and a max chain width of 3 cm.
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 75
- Makes
- 1
- Views
- 1,234
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Share Alike
Please leave a ♥ Like if this print was helpful to you :-)
This is a "clamp-on" design chain holder for the Ninebot G30D escooter and a max chain width of 3 cm. Holds the lock securely in place when not needed and also makes locking it on somewhere much easier.
SEE THIS PRINT FOR OTHER SCOOTERS.
You need:
- ASA to print for outdoor durability
- 4 x M4x20 screws
- 4 x M4 nuts
- Loctite (optional)
A good assortment to get started is something like this.
Print Settings
- Rafts: No
- Supports: Yes
- Resolution: 0.2mm
- Infill: 30
- Filament: Prusament ASA Black
Depending on your printer, supports below the ring that holds the chain might make sense. Choose the infill to your liking, I would recommend at least 20 % - but going beyond 50 % probably doesn't make any sense either.