1 / 3
Skadis/Skådis Parkside 12V Battery Holder / Akkuhalter — zdjęcie 1
1 / 3

Skadis/Skådis Parkside 12V Battery Holder / Akkuhalter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Parkside 12V Battery Holder for IKEA SKÅDIS (45°) // Parkside 12V Akkuhalter für IKEA SKÅDIS (45°)

Ocena
5 / 5
Polubienia
44
Pobrania
246
Wydruki
2
Wyświetlenia
749
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

Parkside 12V Battery Holder for IKEA Skådis

  • Fits all Parkside 12V batteries (from 2 Ah to 5 Ah).
  • The batteries sit (fairly loosely) at a 45° angle in the holder → this way, you won’t pull the Skådis board forward when removing them.
  • Support-free print.
  • Uses the brilliant hook system by @Kim-Janosch.
Printing
  • You’ll also need two of these hooks: SKÅDIS Universal Peg by Kim-Janosch
  • Choose the orientation shown in the photos – this allows printing without any supports.
  • Printed with PLA, 15 % infill, 0.2 mm layer height.

 

Assembly
  • First, hang the two hooks into the Skadis board, them simply clip the battery holder onto them.

------------------------------------------------------------------------------------------------------

Parkside 12V Akkuhalter für IKEA Skådis

  • passend für alle Parkside 12V-Akkus (von 2 bis 5 Ah)
  • Akkus sitzen (relativ locker) im 45° Winkel in den Halter → man zieht beim Herausnehmen das Skadisboard nicht mit vor
  • supportfrei
  • nutzt das grandiose Hakensystem von @Kim-Janosch

 

zum Druck
  • Du braucht unbedingt noch 2 der folgenden Häken: SKÅDIS Universal Peg von Kim-Janosch
  • Druckausrichtung wie auf den Fotos - dann geht's ohne Support
  • Ich habe PLA, 15% Infill bei 0,2mm Layerhöhe verwendet.

 

zum Zusammenbau
  • zuerst die beiden Häken ins Skadis einhängen und dann den Akkuhalter aufklipsen

 

Tagi