1 / 9
Umarex HDR68 / TR68  - .50cal stick magazine conversion kit — zdjęcie 1
1 / 9

Umarex HDR68 / TR68 - .50cal stick magazine conversion kit

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This kit allows you to convert your Umarex HDR68/TR68 into a .50 caliber version to be used with the included stick mag.

Ocena
0 / 5
Polubienia
6
Pobrania
73
Wydruki
0
Wyświetlenia
713
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a kit to turn your HDR68/TR68 marker into a .50 caliber plinker. It is nowhere close to perfect so please take your time to read the description before deciding to print.

 

The kit includes:

  • Stick magazine for ~25 12.4x15mm projectiles
  • Barrel adapter
  • Suitable projectiles
  • Barrel spring spacer (optional)

 


The concept has a lot of issues all together. Here are some main points that need to be taken into consideration when going for this conversion:

  • The magazine only works with 15mm long round nosed slugs. Shorter commercially available projectiles are too short and will flip in the magazine causing a jam. Pointy ones have the same outcome no matter the length.

 

  • You will need to install a .50 cal barrel to make the magazine useful. The files include an adapter that you can glue around a 15.5mm OD pipe. Step files for the adapter are included so you can modify the hole size for what ever sized pipe you happen to have available.

 

NOTE: DO NOT USE THE BARREL ADAPTER WITHOUT AN INTERNAL METAL PIPE! It would most likely burst.

 

  • Use caution when installing the metal tube inside the adapter. You want it to be super tight to begin with. Roughen up your metal pipe with sandpaper before installation so the glue can really grab everything tightly. A loose fitting barrel might turn your marker into a spear gun so make extra sure everything is snug! Getting the barrel adapter right might take a few attempts of filament shrinkage adjusting. You could also just scale the part in size until you're happy. Or use a hole compensation setting in your slicer.. You get the point!

 

  • The size of the magazine needs to be very precise as well to avoid any wobble. It is highly recommended to start by printing only a small section of the magazine halves to see if it's a snug fit for your marker and then adjust your filament shrinkage compensation if needed. A loose fitting magazine can tilt and will be prone to jams. And a magazine that's too big obviously can't fit the marker..

 

  • Depending on your print quality and tolerances, you might have to sand the insides for smooth gliding. The center hole for the magazine lock might also need to be drilled with a 5mm drill bit. You don't want it any bigger than that though. "No wiggle" is the way to go!

 

Hardware needed for the assembly:

  • 5pcs  M3x16 socket head bolts
  • 5pcs  M3 nuts
  • 12mm OD, 0.6-0.8mm CS, 370mm (or longer) spring

 

It is recommended to download the ZIP file rather than the individual files. The zipped folder comes with everything needed and some extra notes attached.

 

A video where I show how to load the magazine:
https://www.youtube.com/watch?v=gq6g2Hfaahs

Tagi