1 / 5
Prusa MK2S & MK3/S feet (for sorbothane dampeners) — zdjęcie 1
1 / 5

Prusa MK2S & MK3/S feet (for sorbothane dampeners)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Feet for gluing sorbothane dampeners to the printer

Ocena
0 / 5
Polubienia
3
Pobrania
14
Wydruki
0
Wyświetlenia
352
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

MK3/S

You will need the following for each MK3/S foot:
1x M4x10 button head screw
1x M4 nut
1x T-Nut ("TNut_3030_M4")
1x Foot of your choosing ("Foot_3030_XXmm")

They will require a T-nut (remixed from: https://www.thingiverse.com/thing:2762571 ) to be inserted into the extrusions, the foot/disc is then screwed into place and then you can glue the sorbothane dampeners to them.

-------------------

MK2/S

I remixed these feet (from: https://www.thingiverse.com/thing:2284645 and https://www.thingiverse.com/thing:2076126 ) to better suit my needs. In my case for 30mm half-sphere sorbothane dampeners.

But since I was fiddling with them anyway, I also added 40mm and 50mm versions.

-The main feet have slots for a zip-tie, so that it can be attached to the printer without tape/glue.

-The frame feet was just slightly modified to make them clip on to the frame itself. Just enough so that they don't fall off when lifting the printer.

 

Tagi