Prusa i3 MK3 Filament Filter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament filter for the MK3 (Not the MK3/S)
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 46
- Wydruki
- 1
- Wyświetlenia
- 632
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This filament filter is (to no ones surprise) heavily influensed by the great filament filter by CNC Kitchen, for the Prusa MK2S.
Put a small square piece of foam in the compartment, push through a pointy piece of filament several times to form a hole, snap it into place on top of the extruder and off you go.
-Make sure the holes are clear after printing.
-Don't jam too much foam into the compartment. Otherwise the foam will grab or stick to the filament.
-Probably not a good idea to use with the filament sensors runout feature, since the filament that it pushes back up again most likely will get stuck in the foam.
-Start with putting the bottom end into the hexagonal hole, and then "lifting" it into place on top.