Prusa i3 MK3 Filament Filter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Filament filter for the MK3 (Not the MK3/S)
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 46
- Makes
- 1
- Views
- 632
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This filament filter is (to no ones surprise) heavily influensed by the great filament filter by CNC Kitchen, for the Prusa MK2S.
Put a small square piece of foam in the compartment, push through a pointy piece of filament several times to form a hole, snap it into place on top of the extruder and off you go.
-Make sure the holes are clear after printing.
-Don't jam too much foam into the compartment. Otherwise the foam will grab or stick to the filament.
-Probably not a good idea to use with the filament sensors runout feature, since the filament that it pushes back up again most likely will get stuck in the foam.
-Start with putting the bottom end into the hexagonal hole, and then "lifting" it into place on top.