$60 Newtonian Telescope 4.5inch 114mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My Newtonian Telescope design featuring a 4.5inch 114mm mirror shown here with a 900mm focal length. Super simple to…
- Ocena
- 0 / 5
- Polubienia
- 35
- Pobrania
- 136
- Wydruki
- 0
- Wyświetlenia
- 1747
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution
My Newtonian Telescope design featuring a 4.5inch 114mm mirror shown here with a 900mm focal length. Super simple to build and designed with so many adjustments there are no mistakes you can't compensate out of the system. Uses very little filament and only commonly available fasteners. Includes an integral arca swiss plate for mounting on a tripod or peak design capture clip.
Parts list
- ~300 grams of filament
- Mirrors via ebay
- 3-6x 3/8 inch threaded rods 36 inches in length via home deport
- 18-36x 3/8 inch nuts via home depot
- 4x 1/4 inch nuts and matching bolts 3/4 inch in length for view piece attachment bolts via home deport, nuts via home deport
- 3x 1/4 inch bolts for objective mirror adjusters
- Focusing mechanism via amazon
- Paper for baffles if desired
Adjusting
The design includes a M42 threaded plate for a focusing mechanism. You could do without this by attaching your optics directly to the side of the telescope and focusing by adjusting the front nuts to move the secondary mirror back and forward. I've also included a small split socket (nutdriver.stl) to make adjustments less tedious as you build the telescope. The main mirror should be glued to "pivot.stl". It can then be aimed using the three bolts on the back of the mirror mount. "Pivot.stl" is best printed in TPU for compliance but PLA should also work.
Category: Physics & Astronomy