Secure Headphone Hanger for Ikea Desks

Secure Headphone Hanger for Ikea Desks
A sleek and secure headphone hanger that attaches directly to your IKEA desk by using the screws that fasten its legs. It is designed to be nice to your headphones with soft, rounded corners, and a rounded contact area that follows the natural shape of your headphones.
The hanger features a long hook, specially made for headphones with wide headbands (up to 76 mm wide), such as the HiFiMAN Arya (as seen in the pictures).

Printing
When printing, I recommend setting the infill density in the area that is in contact with the desk to 100%. The rest can be whatever you want (I used 20% cubic).

Post-Processing
I would highly recommend sanding the two front corners down, as they can come out quite sharp, risking damage to your headphones' ear pads. I also recommend either sanding the surface that will be in contact with your headphones, or using a low layer height in order to lower the risk of damaging the headband over time.

Note that it could be a tight fit — or not fit at all — depending on the tolerances of your specific desk!

Credits
I have not directly used these models, I've just used some of their measurements.

• https://www.printables.com/model/881066 — Size of the headphone hanger & radius of the part that is in contact with the headphones
   
• https://www.printables.com/model/1395323 — Thickness of the part that is in contact with the table & spacing of the screw holes because I was lazy and didn't want to measure it myself

@Mad1723_3772 and @struthers please contact me if you wish for me to take my model down for using measurements from your models!