Bjornagotchi Case w/ swappable battery
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This will allow you to power up and down your Raspberry Pi Zero 2 W devices with a swappable battery
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 760
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This will allow you to power up and down your Raspberry Pi Zero 2 W devices with the addition of a hot swappable battery.
- 6mm x 2mm magnets
- m2.5x6mm screws
- printer and a dream
The parts I used are as follows
Raspberry Pi Zero 2 W
Screen: https://a.co/d/17AqkYy
Battery Case (Needs to be 1.5 version or newer): https://geekworm.com/products/x306
Battery (As long as they are the same form factor and power output any should be good): https://www.amazon.com/dp/B0CDRBR2M1?ref=ppx_yo2ov_dt_b_fed_asin_title
It's not yet built into the model, but I am planning on swapping one of the corners for a heated insert to screw down the faceplate as an option.
I don't have any currently to test with but it would be advisable to use m. 2.5 standoffs to secure down the pie to the board on the side of the screen that does not connect to the pins.
The current features are:
- magnetic faceplate to allow you to access power button and swap SD cards
- hidden slot for an additional SD card inside the case
- from my testing it is completely safe to Plug the device in while swapping the battery to retain power
- Access port for USBCThe current features are:
- magnetic faceplate to allow you to access power button and swap SD cards
- hidden slot for an additional SD card inside the case
- from my testing it is completely safe to Plug the device in while swapping the battery to retain power
- Access port for USBC charging
HAPPY PRINTING!