Tinywhoop canopy for nano sized cameras
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fits cameras such as Caddx Baby Ratel or RunCam Nano 4. Sturdy and rigid, no jello.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
Tinywhoop canopy with standard 25.5mm mounting holes. Fits nano sized cameras (14mm wide) such as Caddx Baby Ratel, Runcam Nano 4 etc.
Fusion360 project included.
Weight is about 1.7 g (polycarbonate, 1.1x extrusion multiplier).
Not the ideal choice if you want the most lightweight build, primarily because nano cameras themselves are heavier than specialized whoop cameras. Use it if you are willing to trade a little bit of weight for the superior image quality. Perfect for 75mm whoops where the small weight penalty is inconsequential.
No jello! The canopy is very rigid and can take some beating. I've been using this design for over a year and I have ironed out most of the weak points. I can't guarantee it will survive a fall from a scryscraper, but it should survive some pretty aggressive indoor flying.
- Print out of PC or PETG
- Requires supports
- I printed mine with a 1.1x extrusion multiplier and raised the temperature by 10°C to ensure good layer adhesion