3DSets Model 17 (Sakura) light set

While Light piece has only a hole for LED obviously, the Cover piece is containing also print settings. Because you want it to be transparent, right? All the text below is related to the Cover piece:

Use clear PETG. Do not even try transparent PLA, it will be translucent, not transparent. Not even little. Nope. I printed mine with Filament PM PETG, I could dry it a bit more for better result, but was impatient.

Also, make sure to use smooth plate along with separation layer. Smoot plate is usually no-go for PETG because it sticks too well, but you need smooth surface for better transparency, so deal with it. But remember to use separation layer of glue stick or something, I use 3DLac and it worked well. Be sure to reapply the separator if you print again over the same spot. Do not try to print PETG on smooth plate without it! It is a good idea to start with nozzle height like 0,1mm higher than usual and see how it goes. 

Everything else is included in .3mf file. Layer height, speed, infill and some more.

My goal was it to be as transparent as possible because the Light piece has some nice details I did not want to be completely lost and avoid postprocessing if possible. What you can see on pictures is just how it came out of the printer, no sanding, polishing, nothing.

Suggestions for improvements are welcome!