DEWALT Pro Organizer (DWS14925) Bins
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Smaller separate bins for the Dewalt Pro Shallow Organizer
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 606
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Introduction
These are even smaller separate bins at ½ and ⅓ the size of the 111 mm x 81 mm bins for the DEWALT DWS14925 organizer. I assume this will work for similar organizers from different brands, but I don't own any to verify that.
About This Design
I wanted the bins to be fully separate instead of creating partitions to fit into original containers. Flattening the tapered walls and removing the retaining feet also improves printability by removing all overhangs. I printed these with no supports and 2 walls + 10% infill on a 0.4mm nozzle.
The tapered walls on the original bins wastes a little bit of space and aren't necessary for them to fit correctly in the main body. However, this does create some issues with the “Half Bin Regular” fitting weird in the corners, which is explained below.
I erred on the side of a wider gap (about 0.5mm between bins) to make them easy to remove individually. The FreeCAD files are included as well if you'd like to fine-tune these further.
Issues/Limitations
The lack of tapered walls means that the “Half Bin Regular” version is slightly too big to fit in the upper compartment. The “Third Bin” fits in the top row, so you can place three of them side by side just fine there.
The lack of retaining feet means that the bins can slide around in the bottom row.
To fix these issues, I created separate “Top Bump” and “Long Bottom” versions meant to fit into those slots in particular for the Half Bins. This also gives you a touch more space in those compartments. If this doesn't bother you, it's fine to just fill the unit with “Regular” bins since the retaining grooves on the lid will hold them in place when closed.
STL Files
- Third Bin Regular - Print as many as needed (set of 3 fits in any slot)
- Half Bin Regular - Print as many as needed (set of 2 fits anywhere EXCEPT the top slots)
- Half Bin with Top Bump Left - Print at most ONE for the top row (pair with a Half Bin Regular)
- Half Bin with Top Bump Right - Print at most ONE for the top row (pair with a Half Bin Regular)
- Half Bin Long Bottom Left - Print at most ONE for the bottom row (pair with a Half Bin Regular)
- Half Bin Long Bottom Right - Print at most ONE for the bottom row (pair with a Half Bin Regular)