1 / 2
Prusa MK3S Z-cable & MMU2S Power Cable Holder V2.0 — zdjęcie 1
1 / 2

Prusa MK3S Z-cable & MMU2S Power Cable Holder V2.0

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Version 2 of Prusa MK3S Z-cable & MMU2S Power Cable Holder

Ocena
0 / 5
Polubienia
4
Pobrania
12
Wydruki
0
Wyświetlenia
77
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I am the originator. This is the updated version of the V1. After about a year since printing, I experienced a failure upon removing (see attached photo). So I updated the design to make it easier to put on and off during cable management, and I strengthened the weak sections noted.

15% gyroid infill at 0.3mm layers with white PLA+. 

Prior to use,  stretch it back and forth several times to loosen the plastic,  put the tab facing either way is convenient for you - Updated 10/18/25

It is designed so that a bit of spring force holds the part securely in place. Use the tab to pull laterally to assist in removal.

Tagi