1 / 4
1.75mm Extruder/Feeder upgrade for Ultimaker 2, 2+, 2+ Connect 3 — zdjęcie 1
1 / 4

1.75mm Extruder/Feeder upgrade for Ultimaker 2, 2+, 2+ Connect 3

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is the Extruder/Feeder from the Ultimaker 2+, which I’ve reinforced and slightly modified.The extruder housing…

Ocena
0 / 5
Polubienia
6
Pobrania
56
Wydruki
0
Wyświetlenia
237
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is the Extruder/Feeder from the Ultimaker 2+, which I’ve reinforced and slightly modified.

The extruder housing has been upgraded by removing the original arm axle and replacing it with a threaded hole for an M5 countersunk bolt. This change improves structural strength and reduces the risk of warping in the extruder arm. Additionally, the top section of the housing has been extensively modified to accommodate a threaded push-fit connector (as shown in the photos).

The extruder arm has also been reinforced: the original connector pegs have been removed and replaced with a hole, countersunk to accept an M3 bolt. This ensures both parts are securely clamped together for maximum durability.

No major additional parts are required to use this extruder—just a couple of standard bolts. Any holes that need threading are already sized correctly and do not require additional drilling.

Hardware Used: M5 x 20 Countersunk 2x M3 x 10 Buttonhead

As always, I look forward to seeing your prints and hearing your feedback!

Printed using Ultimaker 2+

Print Settings

Printer Brand:

UltiMaker

Printer:

Rafts:

No

Supports:

Yes

Infill:

15


Notes:

Use 15% on body but 100% on the Arm

Category: 3D Printer Extruders

Tagi