GM328 Transistor-tester battery holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An enclosure/battery holder for the GM328 transistor tester.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 719
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
An enclosure/battery holder for the GM328 transistor tester. The box has a simple hinge that holds the battery in place under the tester, while leaving the board surface perfectly flush on the enclosure's rounded edge. This leaves all the features of the tester easily accessible, such as the sop contacts.
The enclosure is a tight fit around the pcb (<0.1mm gap). Push firmly the pcb until it snaps into place. M3 screws can be directly fastened on the support.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0.15mm
Infill:
30%
Notes:
Be sure to inspect the infill for connection from the walls to the screw holes. At least two intersecting walls are required to build a sturdy mount. Increase infill if necessary.