1 / 2
ESP32 All Band Radio (JasonKits) "Green Board" Case — zdjęcie 1
1 / 2

ESP32 All Band Radio (JasonKits) "Green Board" Case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Case for JasonKits Green PCB ESP32 All Band Receiver

Ocena
0 / 5
Polubienia
2
Pobrania
24
Wydruki
0
Wyświetlenia
253
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
GNU General Public License v3.0

For this case build it should be noted that i used pin headers for mounting my screen to the pcb along with M3x11mm Stand-off's,

I drilled out the mounting holes on the front panel PCB very slightly using a dremel, the mounting holes for the screen part of the pcb were like a figure of 8 on the screen connection side and i rounded these out to make mounting easier,

I used M3 Knurled Inserts for mounting the screen and also the small PCB and rear cover 

https://www.amazon.co.uk/dp/B0BS3LH9K9?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2

Speakers i used were 20x40mm which i obtained from Amazon : 

https://www.amazon.co.uk/dp/B07LGMKWZG?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_11

for the connections from the front panel to the radio PCB i used Header sockets again and used standard breadboard wires and a small peice of insulation tape to hold them in place and stop them coming loose but you could just solder the wires directly between the PCB's

Tagi