1 / 5
WAGO Lock — zdjęcie 1
1 / 5

WAGO Lock

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

WAGO lever lock for 2, 3 and 5 lever WAGO's

Ocena
5 / 5
Polubienia
165
Pobrania
300
Wydruki
8
Wyświetlenia
1526
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

Thin, easy to print lever lock for 2/3/5 lever WAGOs. Adds some positive retention, without the bulk, to the levers for when you are haphazardly shoving your wires back into the wall!

Easy to clip on and take off. Can still see the end of the wires on the front and back of the connector to verify wires are all the way in.

I've also found myself using it as a rough depth gauge for checking my wire stripping length as well. Unintentional, but convenient!

  • 2 wago lock.stl - 221-412 
  • 3 wago lock.stl - 221-413 
  • 5 wago lock.stl - 221-415 

 

  • 2 wago lock prototype.stl - 221-412 
    • Trying to optimize for strength while maintaining a small snag free size and still needs to clip on and off without too much effort.

Prints very fast ~3-7 minutes

  • No Supports
  • Printed laying flat 
  • Tested with PLA, PETG and ASA
  • Tested with 0.4 and 0.6 nozzles
  • Tested at 0.15, 0.20 and 0.25 layer heights

Note: I only have 2 lever 221-412 WAGOs to test with. I used the measurements WAGO had listed to make the 3 and 5 lever locks. If anyone tries the 3 lever or 5 lever lock let me know how they fit. 

Tagi