1 / 5
WAGO Lock — image 1
1 / 5

WAGO Lock

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

WAGO lever lock for 2, 3 and 5 lever WAGO's

Rating
5 / 5
Likes
165
Downloads
300
Makes
8
Views
1,526
Reviews
5

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

Thin, easy to print lever lock for 2/3/5 lever WAGOs. Adds some positive retention, without the bulk, to the levers for when you are haphazardly shoving your wires back into the wall!

Easy to clip on and take off. Can still see the end of the wires on the front and back of the connector to verify wires are all the way in.

I've also found myself using it as a rough depth gauge for checking my wire stripping length as well. Unintentional, but convenient!

  • 2 wago lock.stl - 221-412 
  • 3 wago lock.stl - 221-413 
  • 5 wago lock.stl - 221-415 

 

  • 2 wago lock prototype.stl - 221-412 
    • Trying to optimize for strength while maintaining a small snag free size and still needs to clip on and off without too much effort.

Prints very fast ~3-7 minutes

  • No Supports
  • Printed laying flat 
  • Tested with PLA, PETG and ASA
  • Tested with 0.4 and 0.6 nozzles
  • Tested at 0.15, 0.20 and 0.25 layer heights

Note: I only have 2 lever 221-412 WAGOs to test with. I used the measurements WAGO had listed to make the 3 and 5 lever locks. If anyone tries the 3 lever or 5 lever lock let me know how they fit. 

Tags