Moon Meteor Pro Light Mount onto Garmin Bar Mount

A mount for a Moon Meteor Pro front light that mounts onto a garmin bar mount. It is effectively this mount from Moon.

I haven't extensively tested this so please print and use at your own risk. I would recommend using PETG or ABS to stop the part from UV corroding during use, and also a high infill to reduce chance of breakages.

Parts You'll Need:

• m5 locking nut
• 2 m3x12mm bolts
• 2 m3 locking nuts
• The moon meteor clip part from the top of the helmet adapter.

Instructions

• Take the garmin mount insert out of the garmin bar mount. You need to undo the 2 screws on the backside.
• Put the 2 m3 bolts into the other empty holes.
• Put the printed part on and tighten it down with the m3 nuts.
• Reattach the garmin mount insert.
• Attach the moon meteor clip to the printed part with the m5 locking nut. Position as necessary.
• Slide on your light.
• Done!

---

16/10/2025 V1: Created part. Assumed the screws for the garmin mount are m3s. I haven't added the radial cutouts on the actual mount bit.

18/10/2025 V2: Rotated partition by 90deg. Decreased thickness of center partition from 10mm to 8.2mm.

19/10/2025 V2.1: Increased chamfer on partition from 5mm to 7mm. Decreased height of 5mm hole from 7mm to 4.5mm. Made m3 cutout holes for the garmin mount through holes instead.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Supports:

Resolution:

Infill:

Filament: Filamentive PETG Blue

Notes:

Category: Sport & Outdoors