9.1L Open-Frame ATX SFF PC Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
All of my previous PC case designs have been for ITX, but with every design I have been asked if it can work with ATX.
- Ocena
- 5 / 5
- Polubienia
- 169
- Pobrania
- 740
- Wydruki
- 0
- Wyświetlenia
- 12 056
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Video: https://youtu.be/IR4NWpqXP5c
All of my previous PC case designs have been for ITX, but with every design I have been asked if it can work with ATX/microATX. This was mostly due to the maximum print size on many printers, so I challenged myself to create a case almost anyone could print that would be compatible with all motherboards.
.32mm Layer Height
3 outer layers
3 top/bottom layers
20% infill (I used cubic infill)
No supports
Requires roughly 200x200x130mm build volume. If you wanted to go just ITX you could chop several of the pieces and get under 150mm, and if 130mm build height is an issue you can put the PSU parts on their side with supports.
ITX and DTX boards need two MB bars, all others need at least three. There is a center support beam slot if you want additional support.
Power Switch: https://ebay.us/Qt6JK2
Standoffs: https://ebay.us/AwwNCX
Thumb Case Screws: https://ebay.us/Na4Uwj
Category: Computer