1 / 9
Aprilia SXV Magura Hymec heat protector, spacer and instructions — zdjęcie 1
1 / 9

Aprilia SXV Magura Hymec heat protector, spacer and instructions

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

It is a heat protector that clips in place for the Magura Hymec with instructions to install for the Aprilia SXV / RXV.

Ocena
0 / 5
Polubienia
0
Pobrania
7
Wydruki
0
Wyświetlenia
87
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I made the Hymec work for the SXV. So I write here for others in the future who want to do this as well.

1. You need Magura Hymec 2100005 (this has a cylinder for 51-53mm working stroke). The SXV has 49mm and Magura says you should take the next bigger size and use a washer if necessary, so that the handle has 4-6mm play (the clutch should't engage by itself when the bike gets hot, so there is play).

EDIT: I switched from the 9,5mm pump to a 10,5mm because for me the 9,5mm needs to be pulled too far back to fully disengage the clutch. So I bought the Magura 10,5 seperately. But you can just choose a different kit or buy the parts seperately if you also want a shorter way to disengage the clutch. And it is still easy to pull. (Magura also has a 12mm pump if you need it even shorter)

2. I got rid of the metal sleve at the front (its about 4mm) and took a steel-plate with 6mm instead. I drilled one hole with a thread, to keep the plate in space. The other hole is for the hydraulic cylinder (I also drilled a shallow cone in it, like the original. Use a 11-12mm drill and drill just the tip). I made is as short as possible to keep it as close to the original position without the rubber sleeve scratching on the metal.

3. Cut off the original rivet from the thing where the cylinder hooks in. Then put a normal M6 screw through the hole, some washers/ or spacers and a nut with loctite 270 from the bottom.

4. I wrapped the cable in a heat protection sleve (for the heat from the exhaust). And I printed a heat shield for the hydraulic cylinder (I used PAHT-CF which can withstand a heat of around 200°C, but maybe ASA-CF that can withstand around 110°C could be enough...) that clips in place (for the heat from the rear cylinder of the motor).

See the pictures to understand everything.

As Printing material I used and recomment PAHT-CF (but maybe ASA-CF will be enogh as well with 110°C).

The file is made with positive and negative cylinders in the slicer. So Bambu and Orca slicer will work, otherwise I don't know.

One file is for the heatshield and one for the spacer.

Tagi