Charge Point Cable boot - covers the end of standard Charge-Point charging cable
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dust boot to cover end of charger cable when not in use. Fits most level 2 home chargers (not Tesla)
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial
I don't use the built in hanger for my charge cable on the level 2 charger because it sticks out from the wall and is too easy to bump into and break the charger. So I made a light cover (see other models) and a dust boot to protect the ends of the charge cable when not in use. Here is the dust cover.
Print this in a soft flex material. Shore 85 A to shore 95A will do nicely. Any color will do.
The design is meant to use a piece of string or cord to tie onto the dust boot (thread it through the obvious hole) and then loop a few times the other end around the charging cord and tie it off. When ready to charge, remove the boot. If it's nice and soft it won't scratch your car. I used Ninjaflex (shore 85a) and the whole thing is a soft rubbery feel. The flex of the flexible material makes it grip the charge cord end when not in use.
No supports required. Easy-TPU, so to speak. Printed this on a MK4S because there is no bowden tube to foul up the TPU printing.