FYSETC Distribution Board mount for DIN Rails
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
FYSETC Distribution Board mount for DIN Rails
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This project is designed to mount the FYSETC_Distribution_Board to mount to DIN rails. This is useful for StealthChanger builds.
Print Instructions: If the mount is inside the printer it is recommended to print in ABS or ASA, otherwise PETG is probably fine. Supports aren't required but may help with the nut openings. I chose 20% Gyroid infill.
Hardware:
4 X M3 nuts or Nylock
4 x M3x12mm tapered head screws
4 x M3x10-12mm Pan or Hex head (for FYSETC_Distribution_Board.stl) or M3x16-18 for FYSETC_Distribution_Board_Tall.stl
Print 2 of the following 52.5mm model from: https://www.printables.com/model/420009-din-rail-bracket-heat-insert-version-525mm-625mm
Assembly:
Use tapered head screws to mount DIN Rail Brackets. Press fit nuts into the openings in the bottom of the model (soldering iron may help if it is too tight). Use M3 screws to go through the distribution board, through the printed part, and into the nuts on the bottom.