1 / 1
Multiboard Spool Rewinder Brackets with Notches
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Use this along with the Integrated Auto-rewind spool holder to mount filament rolls to your multiboard wall.
This model includes two brackets, the axle, and a push-fit ptfe holder.
Additionally, you'll need:
- The IntegratedRewinder parts from Auto-rewind spool holder
- Two 608 bearings, either real ones or print in place. (I've had better luck with real bearings)
- Two Raised Heavy Weight-bearing snaps, for the top bracket supports.
- Two regular raised snaps, for the bottom bracket supports.
- Four 20mm small thread flat head t-bolts, to secure the brackets to the snaps
- If necessary to mount the ptfe holder, you may need a regular flush snap.
The original model recommended using double sided snaps, but I found the raised heavy snaps work just fine and don't require you to take the board off the wall to put the back side snap in.
Everything printed with the usual multiboard settings:
- 3 wall perimeters
- 0.2mm layer height
- no supports
- default 15% infill