1 / 5
Schoko-Stick Mausefalle (Chocolate-stick mouse trap) — zdjęcie 1
1 / 5

Schoko-Stick Mausefalle (Chocolate-stick mouse trap)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mausefalle mit Schoko-Sticks als Köder und Auslöser. (Mouse trap using chocolate sticks as bait)

Ocena
0 / 5
Polubienia
5
Pobrania
37
Wydruki
0
Wyświetlenia
313
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Dies ist ein Remix der PretzelTrap v1.0 von @Nem. Prinzipiell funktioniert die Falle gut, aber ich habe ein paar Modifkationen vorgenommen.

Die Röhren haben eine Nut und eine Feder, dass man sie nicht verdrehen kann. Wenn die innere Röhre herausgezogen ist, kann man sie aber etwas drehen und einrasten, so dass man den Gummi zum Beködern nicht abnehmen muss. Damit man das Gummiband nicht über den Verschluss ziehen muss, habe ich die Aussparungen mit Haltenasen ersetzt. Somit kann man entweder zwei Gummibänder (eins oben, eins unten) oder eines, welches man über die linke Seite spannt, verwenden. Den Verschluss habe ich modifiziert, so dass er sich nicht mehr ganz herumdrehen lässt und außerdem benötigt er keinen Support mehr.

Salzstangen waren bei mir leider oft nicht stabil genug. Wenn sie feucht werden, dann brechen sie leicht und die Falle schließt. Deshalb habe ich Schock-Sticks als Köder und Auslöser verwendet. Diese funktionieren recht gut.

Ich habe meine Fallen mit 0,4er Düse und 0,2 mm Schichthöge bei 15% Grid Infill gedruckt. Ich habe PLA und PETG verwendet. Nach dem Druck die beiden Röhren mehrmals ineinanderschieben oder etwas schleifen, damit sie schön leicht ineinandergleiten.

----------------------------------

This is a remix of the PretzelTrap v1.0 by @Nem. In principle, the trap works well, but I have made a few modifications. The tubes now have a groove and a tongue, so they cannot be twisted. However, when the inner tube is pulled out, it can be rotated slightly and locked in place, so you don't have to remove the rubber band for baiting. To avoid having to pull the rubber band over the closure, I replaced the cut-outs with retaining lugs. This way, you can either use two rubber bands (one at the top, one at the bottom) or one that you stretch over the left side. I modified the closure so that it can no longer rotate completely and, in addition, it no longer requires any support.

Unfortunately, pretzel sticks were often not stable enough for me. When they get damp, they break easily and the trap closes. That's why I used Choclate-sticks as bait and trigger. These work quite well.

 I printed my traps with a 0.4 mm nozzle and 0.2 mm layer height at 15% grid infill. I used PLA and PETG. After printing, push the two tubes together several times or sand them a little so that they slide smoothly into each other.

Tagi