1 / 6
Philips Magnavox FW 560 to 775 speaker grilles — zdjęcie 1
1 / 6

Philips Magnavox FW 560 to 775 speaker grilles

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

90's Philips Magnavox FW 570 to 775 stereo speaker grille

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
46
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

This is a replica of the speaker grille for the 90's stereo system by Philips magnavox, this is for models FW-560 to FW-775. It's not a perfectly exact replica but it's very close. 

 

It prints in two halves so it will fit on most print beds, you'll have to glue them together after printing, I recommend jb weld plastic bonder epoxy for the most secure bond. I modeled locating pins that makes it easy to put them together for gluing.

 

NOTE: When I printed mine the prongs that hold it in the speaker box were in the wrong locations so I had to cut mine and remelt them in the correct place, but I did go back and remodel the locations in this newest version so it should be correct but I haven't tested*

 

SPEAKER CLOTH: 

I used gray stretchy speaker grille cloth by "Findufa" on amazon and attached it to the speaker grille with super 77 spray glue by 3m.

 

CENTER EMBLEM:

I sanded the center emblem, sprayed it with filler primer, sanded again then painted with aluminum color spray paint by duplicolor. I then cut the Philips Magnavox lettering with my cricut vinyl cutting mechine and stuck it on the emblem. 

 

PRINT SETTINGS:

PETG or equivalent strength recommended but any hard filament should work

supports needed

I like to print .28 layer height for highest strength and speed

 

If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ