1 / 6
Philips Magnavox FW 560 to 775 speaker grilles — image 1
1 / 6

Philips Magnavox FW 560 to 775 speaker grilles

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

90's Philips Magnavox FW 570 to 775 stereo speaker grille

Rating
0 / 5
Likes
0
Downloads
4
Makes
0
Views
46
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

This is a replica of the speaker grille for the 90's stereo system by Philips magnavox, this is for models FW-560 to FW-775. It's not a perfectly exact replica but it's very close. 

 

It prints in two halves so it will fit on most print beds, you'll have to glue them together after printing, I recommend jb weld plastic bonder epoxy for the most secure bond. I modeled locating pins that makes it easy to put them together for gluing.

 

NOTE: When I printed mine the prongs that hold it in the speaker box were in the wrong locations so I had to cut mine and remelt them in the correct place, but I did go back and remodel the locations in this newest version so it should be correct but I haven't tested*

 

SPEAKER CLOTH: 

I used gray stretchy speaker grille cloth by "Findufa" on amazon and attached it to the speaker grille with super 77 spray glue by 3m.

 

CENTER EMBLEM:

I sanded the center emblem, sprayed it with filler primer, sanded again then painted with aluminum color spray paint by duplicolor. I then cut the Philips Magnavox lettering with my cricut vinyl cutting mechine and stuck it on the emblem. 

 

PRINT SETTINGS:

PETG or equivalent strength recommended but any hard filament should work

supports needed

I like to print .28 layer height for highest strength and speed

 

If you would like to leave a tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ