herman miller mirra 2 armrest lock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple yet effective part to lock your herman milller mirra 2 armrests because the original rubber ring solution sucks
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 111
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Public Domain
I love my herman miller mirra 2 chair but the design of the adjustable armrest is a total mess. It uses rubber rings to provide friction against a plastic part with teeth. Of course, over time, the rubber wears out and get so loose that the armrest shifts every time you use it.
I'm not a small person but I've never had any need to have the armrest further out than the most inward position. So I made a small printed part that solves this issue. It uses the original screw and can be installed in less than a minute. I hope it helps others to enjoy their chair just that little bit more.
Printed on my bambu lab A1 mini with bambu pla basic in about 5 minutes.