Gridfinity holder til CNCKitchen TS100 / TS101 Adapter + Tip Set

This is a Gridfinity-compatible holder designed specifically for the CNCKitchen TS100 / TS101 adapter and the full tip set for installing heat-set inserts (M2–M8). The holder keeps every tip in one place so nothing rolls off or gets lost on your workbench.

I made this model because I was tired of having the TS100 / TS101 adapter and all the installation tips just loose in a tray, where they roll around or go missing.

CNCKitchen makes an adapter and tip set for the TS100 and TS101 that lets you install heat-set threaded inserts in plastic quickly and accurately, without tearing out the hole or overheating the part. The set includes different brass tips for multiple sizes, from around M2 all the way up to M8, and it’s designed to give you much more control during installation.

This holder is built as a dedicated Gridfinity module. You get defined slots for the adapter and for each tip, so you can instantly see which size you’re grabbing. No guessing, no mess.

The whole point is: pick up your soldering iron, swap the tip, get back to work. Not “where did the M3 tip go this time.”

Features

• Gridfinity base so it fits with your existing Gridfinity setup and sits securely in a drawer, tray, or bin.
• Individual slots/pockets for every tip head in the CNCKitchen set, including the smaller sizes (M2 / M2.5 / M3) and the larger ones (M4 / M5 / M6 / M8).
• A dedicated spot for the TS100 / TS101 adapter so it’s not rattling around loose.
• Fast visual overview: each tip stands upright, so you can grab it easily with your fingers or a small pair of pliers.
• Minimal footprint. Takes up as little bench space as possible.
  This module is meant to sit right next to your portable soldering iron (TS100 / TS101 or Pinecil-style iron), so you can do rework or insert installation quickly and efficiently.

Print settings (recommended baseline for people downloading)

• Material: PLA or PETG. PLA is usually fine because this is just an organizer, not a hot tool itself.
• Layer height: 0.2 mm.
• Infill: ~15–20%.
• Perimeters / walls: 2–3.
• Supports: No. The model is designed to print without supports.
• Orientation: Print with the flat bottom down on the build plate and the holes/slots facing up.

Share your Makes

Please post a Make with:

• A photo of your printed holder in use on your bench.
• Which filament/material you used.
• The slicer settings you ran.
• Any changes/remixes you made (for example: added magnets, resized holes, made a lid, etc.).
  Makes really help other people get a good first print, and they help me decide what to improve or expand next.
  More Makes also usually means more downloads and more likes over time.