Negative volumes for prototyping or sampling
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Apply these to designs in PrusaSlicer to print only a cubed section of it.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Share Alike
When designing it's often useful to print out a small part of it to see how it works, saving time and money. You can set up a couple of extrusions in your design software and toggle them on and off, or you can right click the part in PrusaSlicer, add negative volume, load and select one of these designs to crop the surrounding area out. This will only apply to that part, others won't be affected.
Of course, you can also use this to test designs you've downloaded where you don't have access to the original design. But it's simpler to just use one of these.
If you're printing something large make sure to check for parts that stick out of the 12cm distance from the cube in the middle. You can add a cube negative volume, or make a larger negative volume yourself, as you wish.
NOTE: PrusaSlicer seems to flip this shape and not put it on the bed. So make sure to use the settings in the picture to sort it out. Then you can move it around as you wish.
You can see in the pictures above, one design has white parts showing which will print because the negative volume as loaded doesn't cover what it should. When flipped properly as in the adjustment shown in the picture the cube will appear completely green.
Feel free to alter the design (which is very simple!) as you wish using the Fusion 360 file included.