1 / 3
Housing for Shelly PM mini Gen3 and Clamps — zdjęcie 1
1 / 3

Housing for Shelly PM mini Gen3 and Clamps

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Another take on a box for the Shelly PM, EM, 1PM mini (and other units in the same housing) for cable-mounting.

Ocena
5 / 5
Polubienia
13
Pobrania
84
Wydruki
3
Wyświetlenia
381
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

This is my take on a housing for the Shelly PM mini Gen3 (and probably the other members of the “mini” series as well). I know there are other designs available, but I did not find one that fit all of my requirements.

This housing provides a sturdy protection of the Shelly, has room for two lever clamps (e.g. Wago) and proper strain relief for the cables. Two holes in the bottom allow access to the reset button and LED of the Shelly.

Additional hardware needed:

  • 4 x cylinder head screw M3x16 (strain relief)
  • 4 x cylinder head screw M3x12 - M3x16 (lid)
  • 8 x square nuts M3
  • electrical materials (Shelly, cable, clamps, ferrules etc.) as needed

This model has the following benefits for printing:

  • prints easily in PLA or PETG (all parts on flat side)
  • no supports needed*
  • no special hardware needed (e.g. threaded inserts)
  • nuts can be inserted after printing (no need to pause print)

* I designed the screw holes with a sacrificial layer, so no extra support is needed but you need to clear out the holes with a drill bit after printing. Be aware that this model is optimised for 0.2 mm layer height, at 0.3 the sacrificial layers might be omitted by the slicer.

I uploaded three sets of parts for different cable diameters (6, 7 and 8 mm) for your convenience. If other diameters are needed, please let me know!

Tagi