1 / 1
Parkside PKS 1500 to 35 mm hose adapter — zdjęcie 1

Parkside PKS 1500 to 35 mm hose adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An adapter for Parkside chop saw to allow connecting a 35 mm hose

Ocena
0 / 5
Polubienia
2
Pobrania
20
Wydruki
1
Wyświetlenia
119
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This adapter allows connecting a 35 mm hose from a shop-vac to Parkside chop saw's dust port.

I use a Mirka shop-vac and the fit for the hose is quite snug.

The fit on the saw requires tapping the part in with a mallet (because of the ribs on the port).
It will not fall off on its own, but there is a small gap on the base - if you are concerned, you may seal it with a tape or similar. I did not bother.

Print with PLA with default settings.

The model is confirmed to be compatible with PKS 1500 A2.
Warning: The size is wrong for C4. I have no information about other variants yet.

Tagi